Incandescent Ignition TRIZ Cases
- Preheater Assembly for Aircraft Piston Engine Cylinder Head
A preheating assembly uses a hollow sleeve sheath to secure a glow plug within an aircraft engine cylinder head.
- Sheathed Glow Plug Contact Element Design
An axially moveable contact element compensates for thermal expansion differences, removing insulating powder from the manufacturing process.
- Glow Plug Coil Connection via Laser Welding
Laser welding embeds a tungsten front end coil within a lower-melting-point rear end coil, suppressing embrittlement and breakage at the connection region.
- MEMS Fuse Bypass Circuit Disruption for Safe Detonation
Micro mechanical springs break a bypass circuit under launch forces, resolving safety and reliability contradictions.
- Gas Combustor Modular Connection Seat and Snap-Fit Safety Actuator
Modular connection seat with accommodation slots positions ignition and combustion devices for rapid assembly.
- Glow Plug Graphite Seal Insulating Layer
A glow plug uses a graphite sealing element and an electric insulating layer to connect the heating body.
- Wiring Board Core Interlayer Foil Thickness Gradient
Thicker core metal foil mitigates thermal stress concentration and cracking near the core, enhancing connection reliability in multi-layered wiring boards.
- Pressure Measuring Glow Plug Modular Assembly
A pressure measuring glow plug uses a split housing design to simplify electrical contacting between pre-assembled modules.
- Gas Appliance Ignition Module Battery Leakage Protection
Nested housing and inverted battery orientation shield ignition module components from environmental contaminants and battery material leakage.
- Elastically Deformable Closing Element for Vehicle Heater Combustion Chamber
Axial stretching of the closing element simplifies assembly speed while resolving structural complexity in vehicle heater combustion chambers.
- Heater Junction Recess Design for Thermal Stress Reduction
A heater junction uses a recessed lead insertion to dissipate heat and reduce thermal stress at the resistor connection.
- Glow Plug Sheath Tube Aluminum Control Welded Joint Durability
A glow plug sheath tube maintains specific aluminum and chrome mass percentages to support heating unit welding.
- Glow Plug Pressure Sensor Isolation via Sleeve Routing
A sleeve-shaped pressure transmission element guides the glow current line past the sensor to prevent electrical interference.
- Electronic Detonator Array Identity Code Configuration
Unique position-based identity codes replace GPS dependency, allowing accurate blast pattern visualization and configuration without external signals.
- Encapsulated Electric Igniter for Flashpoint Tester
An electric igniter with an encapsulated wire and traversing mechanism positions the tip inside a container.
- Curved Resistor-Lead Interface for Automotive Glow Plug
A ceramic heater uses a curved boundary between the resistor and lead to distribute thermal stress.
- Cell Phone Cover Integrated Cigarette Lighter
A cell phone cover integrates a supplemental battery and heating element to power an electric lighter within the housing structure.
- Squib Initiation Sequencer for Launch Vehicle Payload Separation
A squib initiation sequencer fires pyrotechnic release mechanisms in a pre-programmed sequence to manage electrical current flow.