Non-Insulated Conductors TRIZ Cases
- Power Cable Interface Tape Coating for Shrink-Back Resistance
A friction-enhancing coating on the tape-conductor interface increases grip, limits insulation shrink back, and improves axial stability.
- Vehicle Composite Cable Assembly With EMC Shielded Power and Communication
Separate shielding for power and communication lines lets one vehicle cable serve EPB and ABS while limiting electromagnetic interference.
- Inorganic Insulation Sheet for High-Dielectric Transformer Lamination
A particle-rich inorganic insulation sheet boosts dielectric strength and thermal conductivity while reducing transformer size and drying time.
- Electro-Optic Gas Barrier Structure for Rearview Mirror Reliability
A conductive polymer barrier and primary seal block gas and moisture ingress, protecting the electro-optic medium in vehicle rearview mirrors.
- Resin composition, copper foil with resin, dielectric layer, copper-clad laminate, capacitor element, and printed wiring board with built-in capacitor
A composite epoxy-polyimide resin with complex metal oxide filler helps PCB built-in capacitors retain capacitance at high temperature while maintaining circuit adhesion.
- Cuboid Silver Powder for Fine-Line Conductive Paste Reliability
Cuboid silver powder with controlled aspect ratio lowers line resistance and disconnection in fine-line conductive paste printing.
- Flat Twisted Wire Conductor Structure for High Flexibility
A flat conductor with more outer than inner elemental wires reduces inner wire crowding and hardening while preserving wiring harness flexibility.
- Shield Cable Tape Layer Structure for Bend-Induced Shield Protection
Tape layers between the insulator, shield, and sheath reduce bending stress, letting the shield move freely and resist damage.
- Ti/Al/Ti Conductive Film Structure for Black Stripe Suppression
A Ti layer fully covers etched Al edges to block light refraction, suppress black level stripes, and keep low-impedance conductivity in display films.
- 3D Nanostructured Metal Film for Neutrino Energy Conversion
A 3D graphene-silicon coated metal film uses conductive nanostructures to boost neutrino interaction and direct current generation.
- Twisted Communication Cable Shielding to Suppress Suck-Out
A bonded metal foil shield and controlled twist pitch keep conductor spacing stable, improving cable flexibility while suppressing suck-out.
- Slit Copper Grain Structure for Bendable High-Conductivity Bus Bars
Controlled center and surface grain sizes let slit copper keep 97% IACS conductivity while resisting cracking in severe bus bar bending.
- Curved Contact Conductor Structure for Stable Elastic Electrical Contacts
A curved, grooved contact conductor replaces spring-based coupling to improve contact stability, conductivity, and manufacturability.
- Ambient-Cure Coatings for High-Temperature Overhead Conductors
A single-part water-based coating helps overhead conductors withstand 250 °C heat and 90 °C water aging without complex curing.
- Anisotropic Conductive Film Composition for Display Panel Corrosion
A metal-bonding additive in anisotropic conductive film blocks electrolyte ions, reducing display panel corrosion in hot, humid conditions.
- Embedded Optical Fiber Checks for Composite Strength Member Defects
Embedded optical fibers reveal fractures in composite strength members using simple light transmission instead of complex OTDR equipment.